Liquid Lite™, the underwater boat light, is design to be installed quickly and easily. And, you won't have to drill additional holes in your transom.

To install:

1. Run the cable leads thru the garboard drain opening and screw the underwater boat light assembly into the existing garboard fitting. The Liquid Lite fitting is 1/2" NPT.

2. Connect the Liquid Lite cable to a 12 VDC on/off switch.

3. Attach the red lead to Positive (+) with the included in line 3 AMP assembly fuse and the black lead to the Negative (-)

Typical installation time from start to finish should be around 30 to 45 minutes.

IMPORTANT: When ordering, be sure to know the style and size of your garboard drain fitting. This is necessary to ensure the Liquid Lite™ assembly will fit and function correctly in your boat.

Contact Tojo Sea Below if you have any underwater boat light questions or need help.

Safety Precautions:

1. Never look directly into the Liquid Lite LED's when the light is turned on. They are very bright.

2. Never remove the underwater boat light assembly while the boat is in the water.

3. Always check and make sure the Liquid Lite assembly is tight in the garboard fitting before launching your boat.

4. Turn power off before removing the underwater boat light assembly.

5. Make sure when the Liquid Lite is installed that it does not extend below the bottom of your boat.

6. Call 561-575-5559 if you have any Liquid Lite problems with the installation procedure or need any technical information.